Dang, 6k?

Is there any benefit to a higher pixel count, if you have to run games at half that resolution? I’ll probably stick with my 1440p

Admiral Patrick:

“All the whores lemmings and politicians other lemmings will look up and shout ‘Save us!’ ‘Please go away’… and I’ll whisper 'no Ok.'”

Not to speak for them, but my understanding is they abhor all calls to violence… And paradoxically, supporting Palestinian freedom is maybe a call to violence?

I don’t want to make claims that don’t exist, but that’s how I could explain them blocking statements like this.

And to be clear, yes, free Palestine!

Motorola would never betray me!

…for the next year or two…

You’d have to ask the dev.

Seems to block a lot of folks, many of them reasonable. To be fair, it also blocks spammers. But it’s deceptive in its implementation, and opaque in its application, and therefore is a bad thing.

Don’t stress it!

Neat, now I want to try to make one of these.

Nice, welcome to the cool club!

Them flags? Red, extremely red.

Hey, that’s just my normal costco trip

Haha too true.

Haha.

Good point. I do nearly everything myself, so I don’t normally consider time and transit…

But I’ll continue doing things myself when it costs that much!

Probably fair.

I was imagining an independent contractor type of guy, but it seems walk wall street owns everything now.

Ah, paradox.

Totally bogus bill. Just replace the damn outlet, you dumbasses.

Also, nearly $300 to replace an outlet? I should have been an electrician.

When we were living in a rental with a leaky propane stove, we got an air fryer and did all of our cooking in it! I shut the gas off to the stove so we didn’t explode.

The air fryer did a great job, and we still use it for small stuff today! Or if it’s hot and we don’t want to heat the whole oven up.

I’d find value in a range selector for the graph - like they have on stock market graphs. Last two weeks, last two months, last year, something like that!

Thanks for this, significantly better than other trackers I’ve seen.

What a freaky fish guy.

I guess this may indeed be a z issue, those diagonal lines could be when the nozzle moved from corner to corner without laying material down.

I don’t think this has anything to do with the material or temperature or anything like that.

I’m not overly familiar with the Ender, but maybe run a bed levelling protocol or other calibration option? The plate is probably toast unfortunately.

Edit: did you switch plates between the PLA and petg? They might be different thicknesses if so.

I hope so! But I thought the cgi in the series was actually quite solid. Time will tell of course.